NLSR

Configuration File Format¶

NLSR is configured using an INFO file.

Example configuration¶

; the general section contains all the general settings for router

general
{
; mandatory configuration command section network, site and router

    network /ndn         ; name of the network the router belongs to in ndn URI format
    site /memphis.edu    ; name of the site the router belongs to in ndn URI format
    router /cs/pollux    ; name of the network the router belongs to in ndn URI format

; lsa-refresh-time is the time in seconds, after which router will refresh its LSAs

    lsa-refresh-time 1800      ; default value 1800. Valid values 240-7200

; log-level is to set the levels of log for NLSR

    log-level  INFO            ; default value INFO, valid value DEBUG, INFO
}

; the neighbors section contains the configuration for router's neighbors and hello's behavior

neighbors
{
; in case hello interest timed out, router will try 'hello-retries' times at 'hello-time-out' 
; seconds interval before giving up for any neighbors (deciding link is down)     

   hello-retries 3                     ; interest retries number in integer. Default value 3
                                       ; valid values 1-10

   hello-time-out 1                    ; interest time out value for hello interest. Default
                                       ; value 1, Valid values 1-15

   hello-interval  60                  ; hello interest sending interval in seconds. Default value 60
                                       ; valid values 30-90
; neighbor command is used to configure router's neighbor. Each neighbor will need
; one block of neighbor command

   neighbor
   {
       name /ndn/memphis.edu/cs/castor        ; name prefix of the neighbor router consists
                                              ; of network, site-name and router-name

       face-id  17                            ; face id of the face connected to the neighbor
       link-cost 20.6                         ; cost of the connecting link to neighbor
   }
}

; the hyperbolic section contains the configuration settings of enabling a router to calculate
; routing table using [hyperbolic routing table calculation](http://arxiv.org/abs/0805.1266) method

hyperbolic
{
; commands in this section follows a strict order
; the switch is used to set hyperbolic routing calculation in NLSR

    state off              ; default value 'off', set value 'on' to enable hyperbolic routing table 
                           ; calculation which turns link state routing 'off'. set value to 'dry-run"
                           ; to test hyperbolic routing and compare with link state routing.


    radius   123.456       ; radius of the router in hyperbolic coordinate system
    angle    1.45          ; angle of the router in hyperbolic coordinate system
}


; the fib section is used to configure fib entry's type to ndn FIB updated by NLSR

fib
{
; the max-faces-per-prefix is used to limit the number of faces for each name prefixes
; by NLSR in ndn FIB

    max-faces-per-prefix 3   ; default value 0. Valid value 0-60. By default (value 0) NLSR adds
                             ; all available faces for each reachable name prefixes in NDN FIB

}

; the advertising section contains the configuration settings of the name prefixes 
; hosted by this router

advertising
{
; the prefix is used to advertised name from the router. To advertise name prefixes
; configure one block of prefix configuration command for every name

    prefix /ndn/edu/memphis/cs/netlab           ; name in ndn URI format
    prefix /ndn/edu/memphis/sports/basketball 
}