Boost FAQ » History » Revision 2
« Previous |
Revision 2/3
(diff)
| Next »
Davide Pesavento, 05/26/2017 11:16 PM
Boost FAQ¶
Installing boost libraries to /usr/local
¶
The following instructions are for those who want to install latest version of boost libraries and have root access
The following commands would install the latest version of boost libraries (at the time of writing, version 1.64.0) to /usr/local
, assuming you have a root access to your machine.
If you don't have root access, skip to the next section.
Note that if you are using Ubuntu, make sure that you have installed libbz2-dev
, otherwise not all libraries required by NFD will be installed
wget https://dl.bintray.com/boostorg/release/1.64.0/source/:boost_1_64_0.tar.bz2
tar xf boost_1_64_0.tar.bz2
cd boost_1_64_0
./bootstrap.sh
sudo ./b2 --prefix=/usr/local install
The following commands should allow compilation and run of NFD with custom install of boost libraries:
cd NFD
./waf configure --boost-includes=/usr/local/include --boost-libs=/usr/local/lib
./waf
sudo ./waf install
# If on Linux
sudo ldconfig
Installing boost libraries to a non-privileged location¶
Follow these general instructions if you are trying to install boost libraries to a non-privileged location (i.e., you do not have root access), but something is going wrong.
Normally, to compile and install boost libraries in non-privileged mode, you would need to issue following commands (e.g., for boost version 1.55.0):
export BOOSTDIR=/home/non-privileged-user/boost
wget http://downloads.sourceforge.net/project/boost/boost/1.55.0/boost_1_55_0.tar.bz2
tar jxf boost_1_55_0.tar.bz2
cd boost_1_55_0
./bootstrap.sh
./b2 --prefix=$BOOSTDIR install
Common pitfalls¶
The common pitfalls is with the boost iostreams library, which is required by NFD, but failed to build because of the missing bzip2 library.
This problem can be easily fixed by downloading and installing bzip2 library, e.g., using the following steps:
wget http://www.bzip.org/1.0.6/bzip2-1.0.6.tar.gz
tar zxf bzip2-1.0.6.tar.gz
cd bzip2-1.0.6
make PREFIX=$BOOSTDIR CFLAGS="-fPIC -O2 -g" install
After bzip2 library is installed, you may recompile and reinstall boost libraries using custom compilation flags:
./b2 --prefix=$BOOSTDIR cxxflags=-I$BOOSTDIR/include linkflags=-L$BOOSTDIR/lib install
Alternatively, you can solve this particular problem by installing development package for bzip2 library (if you have root access). For example, on Ubuntu it would be the following command:
sudo apt-get install libbz2-dev
And then compiling and installing boost without custom compilation flags:
./b2 --prefix=$BOOSTDIR
The following commands should allow compilation and run of NFD with custom install of boost libraries:
cd NFD
./waf configure --prefix=$BOOSTDIR --boost-includes=$BOOSTDIR/include --boost-libs=$BOOSTDIR/lib
./waf
./waf install
LD_LIBRARY_PATH=$BOOSTDIR/lib $BOOSTDIR/nfd
Note that LD_LIBRARY_PATH=$BOOSTDIR/lib
is necessary on Linux platform in order for the dynamic linker to find libraries installed in a location different from one of the folders specified in /etc/ld.so.conf
.
Updated by Davide Pesavento over 7 years ago · 3 revisions