NLSR

NLSR Management

===============

NLSR Management provides:

- command to add(advertise) routes to name prefix list

- command to remove(withdraw) routes from name prefix list

## 1. Control Commands

### 1.1 Add a name prefix

#### command-verb: advertise

This command adds a name prefix to the name prefix list. This command can be accepted on ```ndn:/localhost/nlsr/prefix-update``` prefix.

#### Control Parameters

- Name (required)

### 1.2 Remove a name prefix

#### command-verb: withdraw

This command removes a name prefix from the name prefix list. This command can be accepted on ```ndn:/localhost/nlsr/prefix-update``` prefix.

#### Control Parameters

- Name (required)

## 2. Request format

NLSR control commands are signed interests, whose name has the following form: ```/<prefix>/<management-module>/<command-verb>/<control-parameters>/<signed-interests-components>```

- ```<prefix>``` is ```/localhost/nlsr ```. Each individual command may specify additional prefixes under which that command could be accepted.

- ```<management-module> ```is the name of management module to which the command needs to be dispatched. For example, the name of the management module in this case would be ```prefix-update```.

- ```<command-verb>``` is the command to be executed. For this case this would be either ```withdraw``` or ```advertise```.

- ```<control-parameters>``` is a ControlParameters TLV block wrapped in a NameComponent.

- ```<signed-interest-components>``` are four additional components defined by [ndn-cxx:SignedInterest|Signed Interest] spec.

So, putting everything together, the complete name of a command interest would be ```localhost/nlsr/prefix-update/advertise``` or ```localhost/nlsr/prefix-update/withdraw```

## 3. Response Format

A response from the command interface is a Data that matches the request Interest. The payload of this Data is a ControlResponse block.

### StatusCode

StatusCode  |	Description

------------|------------------------------------

200         |		OK

400	    | ControlParameters is incorrect

403	    | Command Interest is not authorized

501	    | Module or verb is not supported

503         | Feature is disabled